Several Speeds

One analysis can solve the aircraft at several speeds, at one angle of attack and one altitude. Each speed is its own run with its own mesh. The speeds run cheapest first, so the first results arrive in minutes, and one page and one report put lift, drag and moment against Mach on one chart.

Setting it up

  1. In the Flight step, select Several speeds. The step becomes Speeds, and the wizard has no Package or Mesh step.

  2. In Speeds, type the speeds separated by commas, up to 16. Under Typed as, choose m/s or Mach. Mach numbers become speeds in the air set below.

  3. Or fill the list from a Mach sweep: type from, to and step under Or a Mach sweep and select Fill the list.

  4. In Angle of attack, type the one angle that every speed is solved at.

  5. Set Altitude and Temperature against standard, as in Step 3: Flight.

  6. Check the table Each speed, how it is solved and its time. It lists the speeds in the order they will run, each with its Mach number, its method and its time. The line under it gives the time to the first result and to the last.

  7. Select Review, check the plan, and select Launch … speeds.

Each speed is solved as its Mach number asks (see How it is solved). A speed below Mach 0.3 is a single low-speed run on the wall-function mesh. A speed from Mach 0.3 is a high-speed run in two passes (High-Speed Flight). When the list has such speeds, the step adds:

  • What is it?: the body, as in High-Speed Flight. It sets up every compressible speed.

  • Mesh the speeds from Mach 1.2 for the sonic boom, when a speed is at Mach 1.2 or more.

Between Mach 0.3 and 0.5, and up to 110 m/s, you may choose Low-speed (your choice) in a speed’s Method list. The low-speed speeds run first, as they take minutes; the table gives each speed’s time. The Review step shows the points and the memory of each compressible speed.

None starts from another speed’s solution, and each keeps its flow, to view later.

The project page

An analysis over several speeds opens on its own page:

  • Lift, drag and moment against Mach: CL, CD and Cm in three panels on one Mach axis, with how many speeds are solved so far.

  • Each speed: a table in the order they run. Select a speed to open its own results: its loads and its flow.

  • Report: the report of all speeds, with the chart, the table and how each speed was solved. Print it or save it as PDF.