When a Mesh Fails

When a mesh fails, Deneb Aero shows the aircraft in 3D, flown to the place where the mesh failed, and says in plain words what went wrong there and what to do next.

You see this view:

  • in the Mesh step of the wizard, when the first run’s mesh fails (Step 6: Mesh);

  • on a project’s Overview tab, when a run’s mesh failed;

  • from the link beside such a run in the Runs tab.

The view

Each place is marked on the aircraft with a numbered pin; the chosen place is ringed and its spot drawn to size. The spot flies the camera to it, Whole aircraft shows the whole aircraft. Drag to turn and scroll to zoom.

Beside the view:

  • A chip that says what happened: The mesh failed, or Deneb’s mesher could not mesh it when the backup mesher took over (see below). It names the run, for example α 4°, and the place, for example place 1 of 3.

  • The headline, for example The surface crosses itself, then the part and where on it, in your CAD file’s own axes.

  • What happened and Why it stops the mesh.

  • What to do next: the buttons for the fixes Deneb Aero can make, then Or in your CAD, the fix to make in your CAD.

  • The numbers: select it to see the measurements, for experts.

  • When there is more than one place, the list Where it failed, grouped by kind. Select a place to fly the camera there.

What went wrong

Headline

What it means

The surface crosses itself

The part’s skin passes through itself. The mesh cannot be built through it.

The surface has a hole

The part’s skin is open there.

The mesh could not follow a small detail / A detail of the shape was lost

The meshed wall stands off the part’s surface there: the shape has a detail smaller than the cells.

The thin cells along the skin left gaps / did not cover it

The layers of thin cells grown along the skin, which resolve the boundary layer, left too much of it uncovered.

The cells are squashed flat here / fold over here / A cell is turned inside out here

The cells there are too distorted for the solver.

The mesh has a hole here

A cell of the mesh does not close.

A propeller has too few cells

A propeller disk has too few cells to carry its thrust.

The mesher stopped with an error

The mesher itself failed. Copy the details and send them to us.

What to do next

Wrap the part

Deneb Aero draws a new closed skin round the part on this computer, close to yours, and sets the analysis up again with it. The Geometry step says how close the wrap keeps to the CAD. A large part takes a few minutes.

Leave the part out

Sets the analysis up again without the part. Its reference area and span stay as they were. Not offered for the main part of the aircraft.

Check the propellers

Opens the Aircraft tab, where the propellers are placed: move the disk clear of the body, or change its diameter.

Copy the details

Copies the details of the failure, to send to us. We can fix the mesher for your case.

From a project, a fix opens a new analysis, set up again on its Geometry step. In the Mesh step, it changes the draft you are working on.

Trying the run again builds the same mesh: change the geometry first.

When the backup mesher took over

On the Mac app, Deneb’s mesher meshes first. When it fails, the backup mesher (cfMesh) meshes the aircraft instead, more slowly, and the run goes on. The view then shows where Deneb’s mesher failed. You do not have to do anything; fixed there, Deneb’s faster mesher meshes it next time.

If the backup mesher fails too, the view says Deneb’s mesher failed here first, then the backup mesher’s mesh failed too.